Node editing question

[cbauer50]

Thanks everyone for the help.

Carol Bauer

[gj1]

Hi gj1
There is an update but it has not been posted on the downloads page yet.
It was being tested to address some problems with the BlackCat cutters.

It should be on the downloads page later this week

Sincerely
- The Craft Edge Team

I recieved this note from CE after inquiring.
I think we should all wait for the official update to the download page.

[pennsylvaniakate]

Ohhhh, no wonder I didn't notice anything different about it. Still getting a double image when trying to print and cut more than one image with the Cameo. Sent them and email and they are looking into it. Did ask, too, about showing the registration marks on the mat when printing.

[cbauer50]

Hi gj1
There is an update but it has not been posted on the downloads page yet.
It was being tested to address some problems with the BlackCat cutters.

It should be on the downloads page later this week

Sincerely
- The Craft Edge Team

I recieved this note from CE after inquiring.
I think we should all wait for the official update to the download page.

Sorry - I didn't realize that. I just mentioned that I had v. 3.022 and someone asked about it. My bad.

Carol Bauer

[gj1]

It is all good cbauer...this is how things get taken care of.

I did download the one posted, and see that the mat always opens at 19%, for me anyway, so I mentioned to CE also.

Thanks, Kate, for your info about it....and hope the baby is good today :)

[pennsylvaniakate]

Lol, yep, he is always good!

[gj1]

Glad you are enjoying every minute!