SCAL4, Custom cut settings doesn't work properly (PC)
Posted: Sat May 20, 2017 8:03 am
I have some problems with the "Cut settings" dialog. I'm using a Silver Bullet Pro cutter and SCAL4.
I do the following:
1. Create custom "Holder" for my engraving Tool. (This actually works as intended)
2. Set Offset, pressure and so on correctly.
3. Click the "+" next to "Preset to save
4. Set name to "Press Paper".
5. Do 1-4 again with a knife Tool, save as "Cut paper"
... do some drawing in the program, click "Cutter" to open dialog again, and here comes the problem...
6. Select my newly saved Preset "Press Paper"
7. Preset now shows "Press Paper" for ~0.5 second, but then goes back to "<Custom Preset>"
8. Holder, offset and overcut aren't changed to correct values.
9. I now have to select the correct holder manually.
I have made 7 custom presets and two of them works, but the others do as I have explained.
Am I doing something wrong or is it something you could fix?
Jorgen
I do the following:
1. Create custom "Holder" for my engraving Tool. (This actually works as intended)
2. Set Offset, pressure and so on correctly.
3. Click the "+" next to "Preset to save
4. Set name to "Press Paper".
5. Do 1-4 again with a knife Tool, save as "Cut paper"
... do some drawing in the program, click "Cutter" to open dialog again, and here comes the problem...
6. Select my newly saved Preset "Press Paper"
7. Preset now shows "Press Paper" for ~0.5 second, but then goes back to "<Custom Preset>"
8. Holder, offset and overcut aren't changed to correct values.
9. I now have to select the correct holder manually.
I have made 7 custom presets and two of them works, but the others do as I have explained.
Am I doing something wrong or is it something you could fix?
Jorgen
