Craft Edge

Posted: **Mon Nov 07, 2016 8:56 pm**

I'm trying scal4 on my ecraft machine for cutting vinyl. Cut time is 1/2 that of MTC, but letters/shapes are not closing. It's also missing a lot of detail, it looks like someone drew it with a crayon.

It's not the machine leaving tabs. MTC doesn't have this issue.(mtc had issues with turning small ovals into trapizoids...)
scal is on it's default settings.

What am I missing?

Picture attached, it's not the best...

Posted: **Tue Nov 08, 2016 3:52 pm**

Here's a better picture.

Look at the S and B in subaru

The center of the A in madison is not closed.

All of the corners are rounded when they should be straight.

There is no offset adjustment in scal. MTC default is 0.30.

Posted: **Sat Nov 12, 2016 12:47 am**

I'm having the same issue with the Cricut Expression. I am searching and searching for an answer. It's not easy to find! I'm super sad about this. Something that should take me 20 mins has taken me several hours, and I still don't have an answer.

Posted: **Sat Nov 12, 2016 9:00 am**

Have either one of you sent a support request to CraftEdge. They do not drop in here very often. You can find a support request form here. http://craftedge.com/support/support_form.php

Craft Edge

Scal 4 + ecraft = letters/shapes not closing?

Scal 4 + ecraft = letters/shapes not closing?

Re: Scal 4 + ecraft = letters/shapes not closing?

Re: Scal 4 + ecraft = letters/shapes not closing?

Re: Scal 4 + ecraft = letters/shapes not closing?