Craft Edge

Posted: **Mon May 09, 2011 3:08 pm**

Ok so I'm trying to use the "place image" print it, bring the printed graphic to my cutter (a cricut expression) then cut the outline of the svg.It's not working, I'm almost cutting the image but I just can't get it right. In the older version wasn't there a place you could calibrate your printer to SCal? I can't find it.
I don't have adobe photo shop. I do have windows 7, Scal version 2.41, and inkscape. Any ideas? I tried a version on you tube but no matter what I do I can't get it right.
Thanks!

Posted: **Mon May 09, 2011 3:37 pm**

IN Scal look under Cutter and then calibrate..

Posted: **Sun Jun 05, 2011 2:45 pm**

Yes but what does calibrate do? I can't find anything on it. The only reliable method is the hinge technique. Is print & cut on SCAL3?

Craft Edge

I'm trying to use the Print & Cut HELP

I'm trying to use the Print & Cut HELP

Re: I'm trying to use the Print & Cut HELP

Re: I'm trying to use the Print & Cut HELP