Signature to SVG

[UH60Family]

So, my friend is wanting a vinyl sign or decal made for her crafting booth. The logo she would like to use is a handwritten signature that her grandmother wrote for her. Obviously, it's not her name or anything, just the name of the company she is crafting under. I have taken a picture of the item. I know its a long shot, but is there a way to turn this signature into a SVG file so that I may cut it for her. Willing to do the work it takes to get it there, just not sure where to start.

[pastda3]

I have to be honest, I ALWAYS use Inkscape. I had scanned an image of my signature, saved it as a jpeg and traced it in Inkscape to clean it up and reduce some nodes. Then I imported the file to SCAL to cut it. It actually came out pretty good. I'm sure you can trace it directly in SCAL, but I've never tried it.

[Butterfly]

I am with Pasta on this and it isn't an easy chore

[Lola]

can we see the actual photo of the name. Perhaps someone could just do it for you.

[UH60Family]

Here's the picture of the signature. I appreciate any help that I can get. More than willing to try and trace it myself, just thought if someone out there just "loved" doing it, maybe they could give it a shot! Also, I have a pen and pad that I can use on my computer, just haven't set it up yet. Anyone out there using one?

[DogCarbon]

attached is my version.

[wynnepam]

Here is my try at it.

[UH60Family]

You guys are all wonderful! Hopefully after a few month, my skills will be sharpened enough to pass along the help! Thanks so much!