an intricated damask mesh.
If it's cut on chipboard, vinyl or laminated paper...you get the best results.
kindly,
paulo/brazil
http://tinyurl.com/czqfk7
damaskmesh
damaskmesh
- Attachments
-
- damaskmesh-wysiwyg.jpg (100.62 KiB) Viewed 4263 times
-
- damaskmesh.jpg (78.25 KiB) Viewed 4262 times
-
- damaskmesh.svg
- (144.39 KiB) Downloaded 557 times
Last edited by prob21 on Fri Jul 24, 2009 10:26 pm, edited 2 times in total.
-
- Posts: 356
- Joined: Mon Apr 07, 2008 8:55 am
- Location: SCAL2, SCAL1, XP
Re: damaskmesh
Paulo - that's beautiful! Have you cut it yet? How long did it take to cut?
TFS
TFS
Re: damaskmesh
Wow...that's all I can say TFS
Re: damaskmesh
you're welcome
From now on I have began a blog.
Then if you'd like to keep getting my NEW cut files, pls go to:
http://scale-files.blogspot.com/
best,
paulo/brazil
From now on I have began a blog.
Then if you'd like to keep getting my NEW cut files, pls go to:
http://scale-files.blogspot.com/
best,
paulo/brazil
-
- Posts: 597
- Joined: Sun Dec 14, 2008 8:48 pm
Re: damaskmesh
this is awesome!! thanks for sharing!! I went to your new blog great job....I tryed to leave a comment but something came up in red!! not sure if it took my comment I just did my best on hoping buttons were the same hope it worked!!
-
- Posts: 3913
- Joined: Sun Jan 11, 2009 7:16 am
- Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
- Contact:
Re: damaskmesh
Try this to translate the Portuguese to English. http://translate.google.com/translate?j ... ry_state0=lesliefolks wrote:I tryed to leave a comment but something came up in red!! not sure if it took my comment I just did my best on hoping buttons were the same hope it worked!!