Program quitting while in P&C

For your help and questions
Post Reply
jrichards
Posts: 866
Joined: Tue Jul 07, 2009 9:37 am
Location: Akron, Ohio SCAL 2

Program quitting while in P&C

Post by jrichards »

Twice now I have gotten something all set up for P&C only to have the program shut down on me. I didn't have the first one saved so I had to start all over. What is going on? I am very frustrated.
Top
pastda3
Posts: 2044
Joined: Tue May 27, 2008 9:01 am
Location: NW Indiana

Re: Program quitting while in P&C

Post by pastda3 »

Oh no. I hope you get it figured out.

I can't quite master the PnC. My cuts were way off, so I gave up. I know it's me, but I don't have the patience to figure out what I'm doing wrong right now. I even watched a couple of videos. :oops:
SCAL1, SCAL2 V2.044, SCAL3. SCAL4 XPsp3, Windows 7, Windows 10-64 bit, Ink.46, Cricut E, Silhouette Cameo
***My files are not to be sold and are for personal use only.***
Top
Post Reply

Return to “General”