Craft Edge

I'm using Sure Cuts A Lot on a Black Cat Cougar on a Mac. I need to know how I would do a Fill Engraving? So far I've only been able to do outline engraving. I am using the engraving bullet.

Thanks!

So are you talking about removing the metal within a design? If you figure it out can you video it, my dad owns a sheet metal shop and I've seen him do things like that on the mill but didn't know the Cougar could do that...

It would make sense, that if the Cougar will fill with color, that it can also cut a solid area. The key is...... finding out how to set this up on SCAL.

Please, anyone with info on this help us out!!!!

Thanks!
Liz

I have a way to do it with Inkscape. The same principle would work in SCAL or you could import from Inkscape
http://cleversomeday.wordpress.com/2009 ... d-markers/

For outline engraving there is need of little care. As it could cause a cut on metal edge and could damage the metal sheet. But it will be better to make border firstly and than start engraving within the border.