Craft Edge

Posted: **Fri Feb 03, 2012 10:01 am**

Hi, I am very new to SCAL and have been playing around with it today. I am trying to create a frame that has flowers inside. I have put together the basics of what I want and have welded the flowers together, however I am not sure how to weld the flowers to the frame.

Please can anyone help?

I have attached what I have done so far

Nannybonk

Posted: **Fri Feb 03, 2012 12:55 pm**

Loving this file...hope this helps...I put what I did on the tabs for directions in you file. Here it is.

I had to change the number from Scut3 to Scut2 to open it. Don't know if you have to change back or not.

Posted: **Fri Feb 03, 2012 3:14 pm**

You are amazing

Thank you so so much!

Posted: **Sun Feb 05, 2012 8:52 am**

thank you ladies for the file.

Craft Edge

Help for creating frame with cut out inside

Help for creating frame with cut out inside

Re: Help for creating frame with cut out inside

Re: Help for creating frame with cut out inside

Re: Help for creating frame with cut out inside