Overcut or blade offset

HeatherM · Post by **HeatherM** » Tue Mar 01, 2011 5:38 am

This is a feature that would be very good to have. Please?

talanhart · Post by **talanhart** » Tue Mar 01, 2011 6:46 am

I second this. This would be great to have for us vinyl cutters.

pastda3 · Post by **pastda3** » Tue Mar 01, 2011 8:09 am

I would also appreciate this feature.

hkvalerio · Post by **hkvalerio** » Tue Mar 01, 2011 9:00 am

Me too! This would be a great feature to add.

hkvalerio · Post by **hkvalerio** » Tue Mar 01, 2011 8:30 pm

stuartcalls · Post by **stuartcalls** » Tue Mar 01, 2011 9:14 pm

I must be thick headed......what would this do?

talanhart · Post by **talanhart** » Wed Mar 02, 2011 5:22 am

Because of the angle of the blades and depending on the depth (we vinyl cutters use a shallower setting) the software doesn't compensate for this angle, so there is an area that doesn't get cut. An overcut or offset option would allow us to cut beyond the center point of the blade to finish the cut.

DogCarbon · Post by **DogCarbon** » Wed Mar 02, 2011 6:47 am

I too didn't understand completely, now I see the benefits of it.

kodifletcher · Post by **kodifletcher** » Sun Mar 06, 2011 11:25 pm

I mainly do vinyl, and this would help me out a lot!!! I want this feature!! Thanks!!!

Craft Edge

Overcut or blade offset

Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset

Re: Overcut or blade offset