I found this monster and I got it into an outline, my hope is to draw it on the cricut with the gel pens. However, when I put it into SCAL and trace it... It ends up with a 'double' line outline. I just want a single line. Is this possible? I've attached the original... Also any tips on how to do it would be great. I've now been on here six hours trying to figure something that doesn't seem so difficult out! I know there are some pretty awesome people on here so I figured I'd throw it out there!
Thanks!
Can someone help me with this?
Can someone help me with this?
- Attachments
-
- cutemonster.jpg (14.91 KiB) Viewed 1413 times
-
Funkay Monkay Mamma
- Posts: 187
- Joined: Tue Jan 27, 2009 9:24 am
- Location: Nebraska SCAL 1,SCAL 2,MTC4.1,Ink.47
-
sensationallychic
- Posts: 531
- Joined: Fri Jan 30, 2009 2:33 pm
- Location: AZ - windows, ink v.46, scal1
- Contact:
Re: Can someone help me with this?
Once you've traced it, try breaking it apart.
Re: Can someone help me with this?
That was all I had to do! I didn't realize I needed to ungroup after the break apart... duh! Thank you SO much!
-
sensationallychic
- Posts: 531
- Joined: Fri Jan 30, 2009 2:33 pm
- Location: AZ - windows, ink v.46, scal1
- Contact:
Re: Can someone help me with this?
Your welcome...glad I could help!