Page 2 of 2
Re: Help with quatrefoil project?!
Posted: Thu Jul 21, 2011 5:27 pm
by camnbaysmom
Okay, one cut just fine. To make it fit a 12X24 without stretching it so it's enormous, what do you suggest next? I will go watch that video now, thank you for the link! I never thought to go check YouTube.
Re: Help with quatrefoil project?!
Posted: Thu Jul 21, 2011 6:01 pm
by pastda3
- quatrefoil_rs.jpg (59.47 KiB) Viewed 2751 times
Okay, I tried my hand at it and was finally able to weld all three panels. A couple of the shapes had double lines. Once I removed them, I was able to weld. I set it for 24 x 12. It will have to be sized smaller and exact on the mat to get the desired look you're going for. HTH
Re: Help with quatrefoil project?!
Posted: Thu Jul 21, 2011 6:35 pm
by gj1
GREAT design and GREAT effort for assistance...way to go everyone!!!
Re: Help with quatrefoil project?!
Posted: Fri Jul 22, 2011 9:41 am
by camnbaysmom
It's gorgeous and exactly what I was trying to do! Thank you so much for all of your help! Going to go make my first cut with it now. Thank you so much again for taking time out to help with this.
Re: Help with quatrefoil project?!
Posted: Sun Jul 24, 2011 4:57 pm
by hkvalerio
That is a beautiful design. Hope it ended up working for you. Be sure to post pics once you've completed your project, I would love to see how it turned out.