garlic bulb

gilroy gal · Post by **gilroy gal** » Sat Jan 15, 2011 3:07 pm

I would like to cut out a garlic bulb so that light shines through the lines....anyone have a svg file for that?

TIA!

talanhart · Post by **talanhart** » Sat Jan 15, 2011 7:36 pm

Check out this topic. I used a Garlic Bulb in some artwork toward the bottom of the first page. If you think this will work, I can dig up the artwork and post it for you.

http://forums.surecutsalot.com/viewtopi ... lb&start=0

gilroy gal · Post by **gilroy gal** » Sun Jan 16, 2011 12:01 pm

Todd-that would work great if the only areas cut are the black areas!
THANKS!

papasue · Post by **papasue** » Sun Jan 16, 2011 6:17 pm

Hi GilroyGal I live in San Jose so I know where Gilroy is.

Here's my version of a garlic bulb. Two pieces.

Hope this works for you, or someone.

: Screen shot 2011-01-16 at 6.13.06 PM.png (27.8 KiB) Viewed 2349 times

gilroy gal · Post by **gilroy gal** » Mon Jan 17, 2011 6:54 pm

I can't seem to open it....is this a version 2 vs version 1 issue? I have version 1.03 of SCAL.

papasue · Post by **papasue** » Mon Jan 17, 2011 10:29 pm

Sorry, I uploaded it again. Download it again perhaps something happened in the upload there should be no reason why it wouldn't work in SCAL vs 1.

talanhart · Post by **talanhart** » Tue Jan 18, 2011 5:50 am

Sue,
I think it was my file that she couldn't open. I downloaded it at home and it wouldn't import into my version of SCAL 1. I posted a new file separately.

gilroy gal · Post by **gilroy gal** » Tue Jan 25, 2011 6:22 pm

Thanks so much! papasue,that one worked!
Really appreciate it!

Craft Edge

garlic bulb

garlic bulb

Re: garlic bulb

Re: garlic bulb

Re: garlic bulb

Re: garlic bulb

Re: garlic bulb

Re: garlic bulb

Re: garlic bulb