Rolland 60 degree Blades ?

[wendywoo2]

Ok! I have just purchased some rolland 60 degree blades to cut some word books from chip Board, can someone tell me do I still need the deep cut housing?
Thanks
Wendy

[prob21]

I'm not an expert here but I think you just need to change the blade.
I just used the blue housing because I got deep cut blades set from Cricut.
Hope to get that Roland 60 asap
best,
paulo/brazil

[Tingha Treasures]

I just use the blade in the normal housing

[wendywoo2]

Thankyou for your replies, I will now give it ago.
Cheers
Wendy

[Tingha Treasures]

no worries wendy I use the blade for cutting stamps with my E

[coocoo4cricut]

Is that the same as the deep cuts blade?
Thank you

[Tingha Treasures]

I believe so and if you buy them on ebay or at a sign makers costs you heaps less!

[Craigg64]

Hi
I have a few questions about these blades
So what are the benifits of these blades?
Will I still need to do multi cuts if cutting through cardboard?
Would there be any benifit using these blades all the time? I can get a set of 3 here in Aust on ebay for around $20 Aust. That's 3 for the price of 2 standard cricut ones.

Cheers

Craig

Update

I just found this and it confusses the issue in what blades to get

[Tingha Treasures]

well benefit is you can cut thicker material without the deep blade holder.
depends on your cardstock if you still need to do multi cut I guess,certainly cuts stamping rubber with one cut.
No need to use them all the time the normal blade has a different angle 45 degrees and cuts thinner papers better
Im in oz to but bought mine ex USA ebay got 6 even with postage was cheaper than 2 blades in oz.

[coocoo4cricut]

Thank you so much for the info. The ad does confuse the issue a bit though doesn't it?
I will definitely try ebay.