Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Sep 26, 2018 7:15 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Wed May 09, 2018 8:17 am 

Joined: Tue May 08, 2018 2:39 pm
Posts: 3
I have a Silver Bullet professional series, Sure Cuts a Lot 4pro

Have had for almost two years no problems, today I try to cut my stencils and keeps stopping mid cut!!!!!!

Used for business so I cannot be down like this.

Using Windows 10

I have to shut the machine down and try to find my start point to recut again, but still does the same darn thing!

This question has been asked in forums previously by others with no answers.


Top
 Profile  
 
PostPosted: Thu May 10, 2018 6:49 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 394
Is the head most of the way to the left side when it stops? Posting a photo of the cutter right after it stops showing when it stops, would be very helpful.

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
PostPosted: Thu May 10, 2018 8:41 am 

Joined: Sat Apr 28, 2018 11:29 pm
Posts: 2
Have you tried using a design that's worked in the past? Sometimes this can happen with an out-of-range cut if it's set up incorrectly.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group