scal 2 files want open in scal 3

justmonogram · Post by **justmonogram** » Sat Mar 29, 2014 3:59 pm

I rencently dloaded scal 3.It want load my images from scal2..I can see them in the folder but it want load them..any ideas

sstehman · Post by **sstehman** » Sat Mar 29, 2014 4:05 pm

change the extension from .scut2 to .scut3

justmonogram · Post by **justmonogram** » Sat Mar 29, 2014 4:20 pm

I went in and renamed it to scut3 but still dont recognize

justmonogram · Post by **justmonogram** » Sat Mar 29, 2014 4:23 pm

maybe im doing it wrong

papasue · Post by **papasue** » Sun Mar 30, 2014 8:22 am

Are you sure when you renamed that you put the . (period) in front of the .scut3 not scal3?

What steps are you doing to open the file? file/open project? If so what is happening when you do this?

Craft Edge

scal 2 files want open in scal 3

scal 2 files want open in scal 3

Re: scal 2 files want open in scal 3

Re: scal 2 files want open in scal 3

Re: scal 2 files want open in scal 3

Re: scal 2 files want open in scal 3