Double lines cutting through my shapes

kallimom · Post by **kallimom** » Sat Mar 02, 2013 1:38 pm

I finally got SCAL 3 to open after downloading the new version, but not it is cutting two lines through my shapes that are not on the cutting mat? Suggestions?

Janet

dragonlord666 · Post by **dragonlord666** » Sat Mar 02, 2013 2:45 pm

check that your registration AND activation are holding up. sounds like Scal has reverted to demo mode.

if not, contact craftedge and they can reset the activation & registration info to get you working again.

Gaz

Craft Edge

Double lines cutting through my shapes

Double lines cutting through my shapes

Re: Double lines cutting through my shapes