Joined: Thu Aug 20, 2009 4:20 am Posts: 626 Location: Amish Country, PA... using SCAL3, Vista, ink 0.46 with my Cameo. Trying to learn alll that I can.
|
The 5th icon down, on the left, choose the square.
Draw a square, then you can adjust using the "Change" line (right below the icons across the top) with the H and W, then Path, Object to path to have nodes.
(you can also round your corners using the Rx and Ry values)
If your square/rectangle is already in node form, then you can adjust the size by the W and H in the numbers boxes (below the icons)...
The X and Y values on this line is the placement on the screen where x=0 and y=0 is the bottom left corner.
The following is a little bit more advanced: Also, if you shape is not regular, you can tweak the nodes to make it a square by the placement of the x and y values, and the "make selected segments a line" icon. And you can also use the object/alignment and then at the bottom is the nodes selection to get your nodes in a straight line either vertically or horizontally.
|
|