Page 1 of 2
Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Tue Dec 15, 2009 12:36 pm
by sfandm
I have been looking online to see what creations people have come up wit, and can't really find any good ones. So I am wondering if any of you great people on here could share pics and maybe directions of some of the tape dispensers and vinyl roll holders you have made in the past that work well for you.
I am open to any suggestions and ideas.
Thanks so much for sharing and reading
Sonya in TX
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Tue Dec 15, 2009 12:49 pm
by talanhart
I would be interested in something that holds viny rolls as well.
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Tue Dec 15, 2009 6:29 pm
by Linda
There are several different ideas for vinyl holders in this thread.
http://forum.uscutter.com/index.php/topic,21505.0.html
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Wed Dec 16, 2009 3:28 am
by cardmkrLeslie
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Wed Dec 16, 2009 5:25 am
by talanhart
I like the way you used the tubes. That is a great idea!
Here is another system.
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Wed Dec 16, 2009 6:02 am
by Sweetness4713
Todd??? Just love Mr. Hanky on the wall there.> ROFLMAO>>
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Wed Dec 16, 2009 6:56 am
by talanhart
This isn't my house. I found this picture at another BB and I laughed when I saw that on the wall.
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Wed Dec 16, 2009 1:02 pm
by Sweetness4713
LOL.. still cute though..
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Thu Dec 17, 2009 11:07 am
by talanhart
I just had part of my attic finished off for some much needed storage etc. I bought a carpet remant for the floor and it came on a very large and heavy cardboard tube. I will be using your idea for storing my vinyl. Now to get the tube to work so I can cut it with the band saw.
Re: Hoping to get ideas for vinyl roll holders & tape dispensers
Posted: Tue Dec 29, 2009 9:59 am
by HAHowe88
My system might be too large for a lot of you, but I am commercial and really need it like this. I also have a fab shop of iron workers and welders, but any local weld shop or even a high school weld shop could whip this up. It cost me about $100 in materials and just a few hours of time. This could be made much smaller, too.
If anyone is really interested, I can explain how it was done.
This is the unit.
I tried to show you the rods that the rolls sit on. The end are turned down so they are not pointed.
It holds 76 rolls of vinyl. It could hold more, however I had some of the rods omitted on the bottom so I could put 100 yard rolls on the bottom. The top rolls are 20 yard rolls.
-Heath
