Print and Cut registration marks setting

For your help and questions
Post Reply
lorieverhart
Posts: 6
Joined: Sun Dec 15, 2019 2:02 pm

Print and Cut registration marks setting

Post by lorieverhart »

I have seen to go to Cutter>Cutters Settings and you will see your reg mark settings and laser calibration. I am using SCAL 5 and do not see this option on my screen. I am using Cameo Silhouette cutter and the cut is not exact. It is cutting to the left of the image.
Attachments
Untitled.png
Untitled.png (1.34 MiB) Viewed 2320 times
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: Print and Cut registration marks setting

Post by SandyMcC »

As I recall the calibration is built into the firmware on the Cameos. So, the first thing I would do is try the same or similar print-and-cut from Silh Studio and, if it's off in the same direction, then use the calibration correction procedure. Here's a link to Silhouette's page for that:

https://www.silhouetteamerica.com/faq/s ... utting-off
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply