Craft Edge

Hi all! Here's a frame I did up last night and thought I'd share. I'd love to see what you do with it

EDIT: There was a problem with the original round barbed wire frame as all pieces weren't welded. I have edited this post to upload the corrected file. Please forgive any inconvenience this may have caused

That's nice! I have been playing around trying to make barbed wire or finding a picture and trying to convert it. No luck there. Could you make a square frame also?

Coming right up!

Ok Linda, here's the square frame. pm me if you'd like the single barb that I used to create these files....

Thank you! Thank you! I love it!

Your very welcome!

just what I was looking for...also can you make a roll of barbed wire....I am going to hang it on a cross...very talented !!!!!

Love your barbed wire frames - I am new to SCAL - have had DS - should the barbs be welded together so it cuts a complete frame? or should it cut all the way thru each barb ? Just trying to figure out if I am doing something wrong ??

Again great design and so generous to share your work.'

wvcathy

Thank you Cathy for bringing this to my attention. The square frame was OK, but the round frames barbs weren't welded together as you suspected. I have edited the original post to fix the problem. Welcome to the SCAL community BTW! I think you'll love it! I know I do