Craft Edge

I have been trying to weld a box around some words with no luck. I also tried to make a frame. I can do this in Illustrator or Inkscape but thought it would be esier to weld from within SCAL. Has anyone done this? If so, what are the steps?

I believe you will have to do it in one of the other packages. Because of the limited commands in SCAL, it is just easier to do in other package.

Thanks for your help. Kind of looked that way to me but thought I'd ask.

I did it with a frame that was a font. I used a plain square frame TTF dingbat and then welded a #2 inside it. Came out cute! I think the key was the frame. So go find a frame ding and then add your words to that..

I will..Thanks