Craft Edge

I have tried and tried to convert this to put on t shirt for hubby he pours concrete but can't figure out how to seperate please please help on my knees begging

Hi Kermetta,
That watermark across the image is there to remind you that this is a copyrighted image and to make it difficult to convert. Perhaps you can purchase the vector at the site where you got this image.

ok i will then i'll be back

is this what i need

Hi I just ran that picture through Vector Magic, an on line Vector converter http://vectormagic.com/home, and it did a good job of converting it to svg.
It does however need a bit of work because of the copyright watermark. They tend to chop up the image, ie it is doing its job.
However if you know how to use inkscape you should have no problems cleaning up the converted svg file.
Although the official line is you should purchase any copy righted images

Cheers

Craig

ok i have it without the watermark convereted to svg but now need help cleaning it up

I was going to try this, but it would take hours. The svg you have is really choppy looking in draw, and it would cut that wya. It would take forever to try and make it look right. So then I opened the bpm. and that water mark is a good one. It would take a long time to convert the areas of the water mark to what they should be before you could trace. I think you would be better off buying the image, or finding a different one. good luck.

Here you go.
I felt like a challenge
Concrete still needs cleaning up.

Enjoy

thank you thank you you don't know how much this means to me... I have tried and tried you did a great job