Re: SCAL 5 Standard Stops Responding for Print and Cut
Posted: Fri Dec 04, 2020 6:51 pm
I would like to know as well. I'm a similar the same issue. I have a SC2 I unboxed yesterday. Let me explain and excuse me, I'm very new to this. Heres what I am using. Mac Book Pro 2021 M1 chip, SCAL 5 and SC2. I am using the USB connection. Here is how I setup the SC2 for print and cut.
1) Calibraion
Here are the screen shots of the settings.
After I click next the head moves to position to be aligned. There is nothing on SC2 display. NOTE: the very first time I did this the display did change on the SC2. The SC2 longer show any change to the screen.
So at this point I should able to move the SC2 head around using the softer as it says in the directions. It does nothing. I have reinstall the SCAL 5, rebooted the computer and SC2 cutter and reinstalled the software. At this point I am stuck. As for regular function if I was to just cut/pet the image, it works fine. I have also tried to find the individual driver to reinstall. I could not find it. So I reinstalled the software. The last Picture is just the regular cut.
Another NOTE:
If I were to hit the button with the cross hairs and select Y for "mark by computer" then select "Looking for mark" 1,2,3,4 then enter. with will say "cut" it will do nothing, but make a humming sound. Some time it I select the cross hairs and select "mark with computer" it say cutting and start humming.
Hope this makes sense.
1) Calibraion
Here are the screen shots of the settings.
After I click next the head moves to position to be aligned. There is nothing on SC2 display. NOTE: the very first time I did this the display did change on the SC2. The SC2 longer show any change to the screen.
So at this point I should able to move the SC2 head around using the softer as it says in the directions. It does nothing. I have reinstall the SCAL 5, rebooted the computer and SC2 cutter and reinstalled the software. At this point I am stuck. As for regular function if I was to just cut/pet the image, it works fine. I have also tried to find the individual driver to reinstall. I could not find it. So I reinstalled the software. The last Picture is just the regular cut.
Another NOTE:
If I were to hit the button with the cross hairs and select Y for "mark by computer" then select "Looking for mark" 1,2,3,4 then enter. with will say "cut" it will do nothing, but make a humming sound. Some time it I select the cross hairs and select "mark with computer" it say cutting and start humming.
Hope this makes sense.