Page 1 of 1
Cut job keeps stalling
Posted: Tue Jul 16, 2019 7:50 am
by rachellewall
I have Sure Cuts A Lot 4 and the cutter (Titan) keeps stalling in the middle of the cut job. Not sure what the problem is... Any ideas? Thanks!
Re: Cut job keeps stalling
Posted: Wed Jul 17, 2019 9:04 am
by SandyMcC
A number of things can cause that. Run it again and then post the following: (1) A photo of the cutter so that I can see the entire machine (2) A screenshot of the project you're cutting