Craft Edge

I would love to put a scalloped edge on my 12 x 12 page.... I know it would make the paper smaller but that's ok..... Does anyone have a suggestion how to do this... I know it's probably very simple, I just don't know how. TIA

Hi,
Perhaps this might be what you are after........
http://forums.surecutsalot.com/viewtopi ... lop#p20861
HTH

It is very simple in Inkscape, not necesarily as simple to explain how.

• First you draw a square, 12"x12"
  For my example I am using 1" circles. Draw 1.
  I select my circle, and by pressing the space bar while holding the mouse button, I can make "stamped" copies of the circle. I do this on one side of the square, then select those circles and repeat for the other sides.
  Using the alignment tools, align the circles against each edge of the square
  Using the distribute tools, distribute the circles by the centers on each side of the square.
  Delete the square
  Select all (control A)
  Path/Union
  Path/Break apart
  Click off the drawing. Select the center part and delete.

Let me know if I am not clear.

TFS the svg as well as directions on how to do it!

Thanks so much.... That is exactly what I was looking for. Love being able to get help here.... Thanks again....