Page 1 of 1
Program Problems - Help needed asap
Posted: Tue Aug 22, 2017 6:56 am
by baddoggraphix
I use SCAL 4 Pro. About halfway through a project my program just stops. I ended up having to Ctrl, Alt, Del to close the program and then restart. What can I do to fix? I have Win 10.
Sandy Hubbard
Re: Program Problems - Help needed asap
Posted: Tue Aug 22, 2017 11:43 am
by papasue
Go to craftedge.com and fill out a support request as craftedge rarely visits here. When u get the fix we'd like to know how to fix as well
Re: Program Problems - Help needed asap
Posted: Tue Aug 22, 2017 4:11 pm
by SandyMcC
What cutter are you using and how are you connected to it from SCAL?
Re: Program Problems - Help needed asap
Posted: Wed Aug 23, 2017 11:38 am
by baddoggraphix
papasue wrote:Go to craftedge.com and fill out a support request as craftedge rarely visits here. When u get the fix we'd like to know how to fix as well
all they told me was to make sure the driver was downloaded...well it does cut until approx until halfway, so apparently I have the driver, lol. I have been using it for over a year and it just started do this.
Re: Program Problems - Help needed asap
Posted: Wed Aug 23, 2017 11:39 am
by baddoggraphix
SandyMcC wrote:What cutter are you using and how are you connected to it from SCAL?
I am using an MH cutter connected by printer cord.