Craft Edge

I spent about an hour and a half today trying to solve this issue. I came to this board and the answer was to uncheck show cut lines only, but that was not my problem. I finally found the issue and it was on the Page setup (Documents) section.... the Workspace alpha value was it . It was set to 0, so no colors showed. But what was really confusing is that Patterns worked and showed fine. Just thought I would post this in case anyone else has this issue.

Thanks for sharing the answer...I know many users will find it as useful as you did

Hello, you have made me one happy camper. I don't visit the forum often, I don't craft often. But today was the day. For some reason, my shapes were not showing up. I spent more than an hour trying to find the problem. One minute on the forum and you had my question answered. Thank you so very much!! I set the Workspace Alpha to 100, is that too much? My shapes are showing up. Thanks again.