I recently bought a Silver Bullet cutter, but haven't done much cutting yet. We are mostly still experimenting.
- At first we just sent the mat and paper through, but most cuts would not be precise.
- Then I tried to straighten out the mat while cutting, and this was much better!
- Today I started to make a more permanent solution, and although it is a little rough in the edges and it isn't finished yet, I like it a lot
The cutter is now placed ~12cm below the table, which ensures that the mat is horizontal at all times. By moving it away from the wall, I can also use my 60x90cm mat without problems.
Not exactly a cutting project, but...
Re: Not exactly a cutting project, but...
Glad you found a solution to your problem.
SCAL1, SCAL2 V2.044, SCAL3. SCAL4 XPsp3, Windows 7, Windows 10-64 bit, Ink.46, Cricut E, Silhouette Cameo
***My files are not to be sold and are for personal use only.***
***My files are not to be sold and are for personal use only.***