Craft Edge

I have a Roland STX-7 I am using a Mac Mini and a parallel to usb cable, I am trying to get Sure cuts alot4 to work, when I test connection the pen moves back and forth the rollers do not move, and the light on the plotter flashes. I have tried Roland GX, CX, PNC, and Stika with the same result. If I try and send a cut file the green bar goes about 3/4 of the way and stops, the plotter does nothing.

Mike

I have tried to install the USB driver, the software tells me to connect and turn on my plotter so it can install the driver, my plotter is connected, and turned on. Has anybody else been able to install the USB driver for Roland?

Mike