Page 1 of 1
Saving text to a path
Posted: Sun Jun 22, 2014 7:35 am
by taranscott3941
When saving text to a path in SCAL 3 when you re-open the saved project it is jumbled up and not like I saved it. What causes this and am I doing something wrong prior to saving the project. Thanks in Advance.
Tara Sullivan
Re: Saving text to a path
Posted: Sun Jun 22, 2014 9:10 am
by papasue
Hi, it might help if you post the file as you see it wonky.
I'm guessing that you might have forgotten to "release" the text from the path. At about 3 minutes into this video Kay shows you a couple of ways to release the text from the path.
http://cleversomeday.wordpress.com/2010 ... t-on-path/
But if you post the file someone can take a look and figure it out for you.
