Page 1 of 1
Double lines cutting through my shapes
Posted: Sat Mar 02, 2013 1:38 pm
by kallimom
I finally got SCAL 3 to open after downloading the new version, but not it is cutting two lines through my shapes that are not on the cutting mat? Suggestions?
Janet
Re: Double lines cutting through my shapes
Posted: Sat Mar 02, 2013 2:45 pm
by dragonlord666
check that your registration AND activation are holding up. sounds like Scal has reverted to demo mode.
if not, contact craftedge and they can reset the activation & registration info to get you working again.
Gaz