Craft Edge

Hello everyone, I am very new to this forum and to SCAL. I have a Pazzles machine and I just love the cut I am getting using SCAL , far better than cutting from the PI software it is very clean and I am now cutting accurately first time every time so no long wasting loads of card.

However, I am digressing! I am slowly learning the programme but can't find out what all the options on the trace function do, is ther any help on this anywhere please? I have tried changing the different combinations but not sure what I should be looking for or achieving!?

Thank you Anne

This link will take you to the video tutorial from craftedge on trace
http://craftedge.com/tutorials/tutorials.php#19

Thank you, I will have to look at the video tomorrow as my computer is off and I can't view it from my iPad which is a pain, I didn't realise that iPads can be very annoying at times and restrict certain actions - grrh!