Craft Edge

Can someone please make a word book for me that says TAYLOR? I made a few of them but can't seem to get it quite right. I would really appreciate it. Toni

What font do you want? How tall top to bottom?

Posts below...this one did not work out.

5 inches high would be good. Braddin font if you have it. Doesn't really matter. She doesn't want the letters to hang off the page though she wants to be able to stand it up. She is making it for her friends grandson. Thanks Toni

and sorry to seem picky but she wants the letters to actually be connected to the end of the rectangle. Hope that makes sense.

I did not think you would post yet again this morning and I made another one...but I keep thinking it is for a girl and picked a curly letter this time and they hang off at the bottom. I will start again maybe later with all capitals and see if I have the font you want.

For Taylor girls though...here is this one :)

Could not find the font you mentioned.
This is the best I can do...I learned a few things, so thanks.
Hope it works.

PS: I should add here in case you don't see the next post...you will have to transfer the two round holes to all the pages before cutting with copy and paste in place.

You will have to copy and paste in place the two round holes to each page when you cut...I only put them on the top page...sorry.

Thank you the bottom one is great for my sister to make for her friend and the fancy one she can use for her daughter because her last name is Taylor. You are awesome!