Page 1 of 1
SCAL 3 and Robo
Posted: Sun May 01, 2011 7:02 am
by hellma
I have just tried scal 3 with my craft robo for the first time and all i can say is thankyou you guys. It is perfect i started both Cricut and Robo at the same time cutting the same file Robo already finished cricut only half way there. So a great big massive thankyou from me to you.
Re: SCAL 3 and Robo
Posted: Sun May 01, 2011 10:25 am
by pennsylvaniakate
Did you try this on the same computer, as there have been questions about cutting from SCAL 2 & 3 simultaneously from one computer?
Re: SCAL 3 and Robo
Posted: Sat May 07, 2011 4:14 am
by fruity46
Hi I 2 have tried scal 3 with my craft robo lite and good results but only for my first cut.
I now have most of the cutting mat that does not cut or it seems to cut the opposite to what I have to cut . Hope this makes sense and hope someone may have a answer, but before I go I have tried to change the page both ways ( landscape & portrate)but still the same