Page 1 of 1
Re: Use Boss Kut Designs with SCA?
Posted: Thu Feb 28, 2008 4:42 pm
by CBJPL31
Deleted
Re: Use Boss Kut Designs with SCA?
Posted: Thu Feb 28, 2008 4:48 pm
by susibi
OK - now open Inkscape and import the jpeg.
The go to Path>Trace bitmap
When the window opens set the brightness threshold at 0.650
Click on update then ok and the window will close.
Click on the image on your page , move it to one side and delete the original image.
Save as .svg
HTH
Susibi
Re: Use Boss Kut Designs with SCA?
Posted: Thu Feb 28, 2008 4:52 pm
by susibi
OK I've seen the .svg - it opens perfectly in SCAL but remember you can't share as it's copyrighted so if I were you I'd remove the link as I was able to access it no problem!
Susibi
Re: Use Boss Kut Designs with SCA?
Posted: Thu Feb 28, 2008 4:53 pm
by CBJPL31
susibi wrote:OK - now open Inkscape and import the jpeg.
The go to Path>Trace bitmap
When the window opens set the brightness threshold at 0.650
Click on update then ok and the window will close.
Click on the image on your page , move it to one side and delete the original image.
Save as .svg
HTH
Susibi
Wait....why am I doing this?
I just cut the file.
I am super-excited!!!
But I'm confused about this step?
What is the purpose of changing the brightness threshold?