Page 1 of 1
how do I get 2 images to union/path together
Posted: Thu Sep 16, 2010 1:20 pm
by sweetpeahome
I don't know the correct term. What I want to do it take a border punch and add it to the edge of a rectangle so that it looks like I used a really punch such as Martha stewarts to cut the edge of the card. the punch is the one that is scalloped on the edge and then has little dots taken out. When I use path all the dots are gone. Tried another was but it has the line across that will cut it right off.
Laura
Re: how do I get 2 images to union/path together
Posted: Thu Sep 16, 2010 7:16 pm
by Butterfly
Go watch this video and it will answer all your questions
http://svgcuts.com/blog/2010/05/26/sure ... -tutorial/
if it doesn't don't be afraid to ask more
Re: how do I get 2 images to union/path together
Posted: Mon Oct 18, 2010 9:02 pm
by sweetpeahome
Looks like a spammer
Re: how do I get 2 images to union/path together
Posted: Tue Oct 19, 2010 5:37 am
by firstcut
There are 2 ways to accomplish what you are trying to do.
Use path exclude to "cut out" each of the small circles from the scalloped piece before you weld to the rectangle
OR
move all the circles off to the side, weld the scallop to the rectangle and then replace the small circles on top in their original positions.
Re: how do I get 2 images to union/path together
Posted: Tue Oct 19, 2010 10:12 am
by Butterfly
Yes that link will take her to the weld video
Re: how do I get 2 images to union/path together
Posted: Tue Oct 19, 2010 1:02 pm
by jennifer mcquillan
Laura do you have Scal 1 or Scal 2 Because with Scal 2 if you use PATH / UNION the circles do not disappear. I just tired it and it works fine on mine. Or are you using Inkscape?
Re: how do I get 2 images to union/path together
Posted: Sun Oct 31, 2010 5:21 pm
by sweetpeahome
I am using scal 2