Page 1 of 1
Basic help needed!
Posted: Sat Feb 20, 2010 5:33 pm
by boysboysboys
I have SCAL2 I typed in a word and have a graphic that I want to weld together to make 1 piece. But when I click weld, I loose the inside of my letters---like a lower case a--in the preview the middle of the a is not there, so when it cuts it will not have the center piece...what am I doing wrong? HELP!
Re: Basic help needed!
Posted: Sat Feb 20, 2010 6:52 pm
by Deloris
Can you upload the file your working on so we can take a look at it?
Re: Basic help needed!
Posted: Sat Feb 20, 2010 8:24 pm
by boysboysboys
I finally got it to work, after much frustration!!!!
Re: Basic help needed!
Posted: Sun Feb 21, 2010 11:16 am
by pennsylvaniakate
Yeah, I've had that problem. You have to ungroup and uncheck the weld for that center piece.