Craft Edge

Could someone please give me some help on figuring out how to convert the files for the Bandits logos.

I am looking for an image of a deer (buck) that I can use to etch the glass on my husbands gun cabinet. The image could have some trees along with it. The area I would like to etch is approximately 8" X 12". Thank you.

Check out this topic. You could just delete the Welcome part.

http://forums.surecutsalot.com/viewtopi ... hilit=deer

I do like that deer. Thanks!! Now I am going to sound really dumb....I have not work with SCAL very much. Can you tell me if and how I can delete the "Welcome" part.

PM me your e-mail address and I will send you something that might work.

MSGRANDMA wrote:Could someone please give me some help on figuring out how to convert the files for the Bandits logos.

I tried to trace for you in Inkscape, but the resolution of the pictures were too low. Traced image was a mess and it would take too long to clean up all the nodes. Do you have a higher resolution picture of the bandits logo that you can post?

Deloris,
Check out this topic.

http://forums.surecutsalot.com/viewtopi ... =6&t=11685

talanhart wrote:Deloris,
Check out this topic.

http://forums.surecutsalot.com/viewtopi ... =6&t=11685

That turned out great. What program did you use to trace the low resolution image?

I didn't trace it, I had to redraw the whole file using the pen tool in Illustrator. As you know, the file was too low of a resolution to trace well. I didn't trace the baseball. I used the SVG file that was posted by Heather. Thanks Heather.

move svg bandit logo to other thread Todd posted!

Laura