Page 2 of 2
Re: Scal Pro version
Posted: Sat Nov 03, 2012 8:12 am
by Jax
You guys need to send CraftEdge an email via the Craftedge site to get your answers. I've noticed that if you email them you'll get your answer within a day but posting it here it could take a while because they don't actively check the forum.
Re: Scal Pro version
Posted: Sat Nov 03, 2012 5:04 pm
by Rachell
sandyj wrote:Will this cut to my cut3000 (GCC Bengal) cutter?
If not, are you planning on adding it to the list? I would be very interested as I dislike the software I have now - you design in a vector program such as corel and then send the design to the cutting interface which I have not so much control over. I would be very interested in using SCAL for my vinyl cutter. I'd also like to get it on sale, so if it doesn't currently cut to the Bengal or GCC cutters but are planning on adding them to the list, I'd pick it up now.
It does list the gcc cutter as one of the cutters you can choose from
Re: Scal Pro version
Posted: Sat Nov 03, 2012 8:10 pm
by sandyj
Not the first time I missed something obvious! Where did you see that?
Re: Scal Pro version
Posted: Sun Nov 04, 2012 5:34 am
by gj1
Click on Cutter at the top and then My Cutter at the bottom of the drop down list of machines, and it is there.
Re: Scal Pro version
Posted: Mon Nov 05, 2012 8:36 pm
by sandyj
Oh, do you mean in the software itself? I didn't download it, I was just looking on the product page. I will have to do that and give it a try-thanks!