Page 2 of 2
Re: Help! scal 2 not working
Posted: Wed Jun 16, 2010 8:25 pm
by happy2scrap56
drivers are fine, its the program
Re: Help! scal 2 not working
Posted: Thu Jun 17, 2010 2:45 am
by Deloris
happy2scrap56 wrote:drivers are fine, its the program
Check out my post from last week and install this new driver:
http://forums.surecutsalot.com/viewtopi ... =6&t=12999
It's a different driver than the one on the Craftedge site and it fixes the freeze problem that occurs on some Windows computers when you click on cut. The problem is caused by one of the Windows drivers that stalls or times out and this new driver will stop that from happening.
Re: Help! scal 2 not working
Posted: Thu Jun 17, 2010 7:46 am
by djevans
try contacting Michelle at Scrapping Table. She is wonderful to help and very smart.
Re: Help! scal 2 not working
Posted: Sat Jul 24, 2010 3:10 am
by happy2scrap56
here it is July 24th and still no rply from upport, whata waste of money.Thank God for MTC
Re: Help! scal 2 not working
Posted: Sun Sep 12, 2010 4:04 pm
by Mary505
I have to say THANK YOU to craft edge support, I was having a hard time with the manual activation code, I emaild
support@craftedge.com and was answered with in an hour of asking my question.
Thanks again,
Mary