Barbed Wire Frame

[sensationallychic]

Hi all! Here's a frame I did up last night and thought I'd share. I'd love to see what you do with it

EDIT: There was a problem with the original round barbed wire frame as all pieces weren't welded. I have edited this post to upload the corrected file. Please forgive any inconvenience this may have caused

barbwirecircle.svg.png (23.5 KiB) Viewed 8172 times

[lindamac]

That's nice! I have been playing around trying to make barbed wire or finding a picture and trying to convert it. No luck there. Could you make a square frame also?

[sensationallychic]

Coming right up!

[sensationallychic]

Ok Linda, here's the square frame. pm me if you'd like the single barb that I used to create these files....

[lindamac]

Thank you! Thank you! I love it!

[sensationallychic]

Your very welcome!

[btails]

just what I was looking for...also can you make a roll of barbed wire....I am going to hang it on a cross...very talented !!!!!

[wvcathy]

Love your barbed wire frames - I am new to SCAL - have had DS - should the barbs be welded together so it cuts a complete frame? or should it cut all the way thru each barb ? Just trying to figure out if I am doing something wrong ??

Again great design and so generous to share your work.'

wvcathy

[sensationallychic]

Thank you Cathy for bringing this to my attention. The square frame was OK, but the round frames barbs weren't welded together as you suspected. I have edited the original post to fix the problem. Welcome to the SCAL community BTW! I think you'll love it! I know I do