Wrong cut-results.

For your help and questions
Post Reply
Posts: 47
Joined: Tue May 12, 2015 4:15 am
Location: Booischot BELGIUM

Wrong cut-results.

Post by Snijderke »

When I draw a triangle with X = 100mm. and Y = 200mm., than the cutted output = X = 100mm. and Y = 198mm. I use a GCC-iCraft cutter.
System = Windows 10, 16GB
Software = SCAL4-Pro (same wrong results with SCAL5-pro).

Anyone some solutions? Thanks in advance.
Gerard Van Kerckhoven.
Posts: 1102
Joined: Mon May 09, 2011 7:01 am

Re: Wrong cut-results.

Post by SandyMcC »

Hi Gerard! I recognize your name and I know you have a lot of experience, so I apologize in advance if I respond with things you already know. So, possible causes:

1. Speed is too high for cutting the particular material and slippage is occurring.

2. One or more pinch rollers and/or grit shafts are sticky and causing some slippage.

3. Scale calibration is required. It's not unusual for a cutter to need the sizing calibrated. The location for the calibration is under Cutter>Cutter Settings. Here's a step-by-step method to test and calculate the required setting to enter.

https://drive.google.com/file/d/1SVa-Sd ... drive_link
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply