Craft Edge

I upgraded my PC to Windows 10, 32 bit. Re-installed SCAL5 and libcutter. Same problem, still leaving parts of rectangle uncut. The design cannot get any more basic than inserting one of SCAL's own shapes. Don't know what else to try.

I saw your posting on Roxanne's FB group and between her group and contacting Craft Edge, you're doing the only two things I could possibly suggest. So sorry.

Hey, finally happy to find others with the same issue as me, I don't remember this happening when I first got SCAL setup, but as long as I can remember I've had these un-cut portions of straight lines.

Has anyone discovered a solution?

I joined the Facebook group and will check there as well.

Thanks!

I'm glad you joined the FB group. You're far more likely to find help with this issue there, than here. Good luck! Fingers crossed!