Search found 3 matches
- Sun Dec 13, 2020 7:31 pm
- Forum: General
- Topic: Cut setting.
- Replies: 1
- Views: 1553
Cut setting.
When I'm setting up the cutter with the pen tool, the shape does not show up on the right side of the screen. If I select cut the shape shows on the right. I want to use the pen tool. I've used it before with no issue. What am I doing wrong.
- Sat Dec 05, 2020 8:16 pm
- Forum: Print and Cut
- Topic: SCAL 5 Standard Stops Responding for Print and Cut
- Replies: 14
- Views: 18371
Re: SCAL 5 Standard Stops Responding for Print and Cut
I did try that too. Here's what happens. Once I start the calibration and select next, the SC2 will flash "finish" on the screen. Then "system idle". On the next screen the direction say to use the arrow on the screen. Weather you use the key board arrow or the arrows on the scre...
- Fri Dec 04, 2020 6:51 pm
- Forum: Print and Cut
- Topic: SCAL 5 Standard Stops Responding for Print and Cut
- Replies: 14
- Views: 18371
Re: SCAL 5 Standard Stops Responding for Print and Cut
I would like to know as well. I'm a similar the same issue. I have a SC2 I unboxed yesterday. Let me explain and excuse me, I'm very new to this. Heres what I am using. Mac Book Pro 2021 M1 chip, SCAL 5 and SC2. I am using the USB connection. Here is how I setup the SC2 for print and cut. 1) Calibra...