Craft Edge

I am looking for the fish from Dr. Seuss to put up in a classroom.I found a picture, imported and traced. But is seems the one fish would not cut right. Any suggestions?

Thanks you.
These are images from inkscape.

There is a better image here. http://www.boulder.swri.edu/~joel/images/seuss/fish.gif If you set your threshold to 0.35 instead of 0.45 it will give you pretty much just the black lines. HTH

Thanks-that image is better but when I try to cut there is too many lines. Please help me figure this out.
tina

I sent you a couple of PM's

How do the lines of the fish separate? Are they each one line that you have to paste on one at a time? Sorry if it's a silly question