Page 1 of 1
sloooooowwww
Posted: Fri Mar 21, 2008 7:00 pm
by scrappy_happy_moms
Hi again! My bug runs fine when I am cutting a welded word. But when I go to cut the shadow for that word my bug runs very slow. I have the speed adjusted to max and its still slow. Any suggestions?
Re: sloooooowwww
Posted: Fri Mar 21, 2008 7:24 pm
by kelsie94
yes, it's a lot slower when using the shadow feature! hopefully Todd will fix it soon.
Re: sloooooowwww
Posted: Fri Mar 21, 2008 7:41 pm
by scrappy_happy_moms
ok Thanks I wanted to make sure I wasn't the only one!
Re: sloooooowwww
Posted: Sat Mar 22, 2008 4:35 pm
by edie
Mine is beyond slow..I mean for a welded 5 letter word that is only 1 1/2 inches by 4 inches..It is still cutting while I registered here, checked my ok, re-routed, signed in, and am posting ..and yep it is still cutting...so i don't even know if it's a good cut yet!!! I'm wondering if certain fonts just blog it down. I can't do a shadow yet because when I checked shadow it gave me an inkblot!!
I am not liking this much..thankfully I haven't sold my wishblade yet!
edie
Re: sloooooowwww
Posted: Sat Mar 22, 2008 5:07 pm
by scrappy_happy_moms
edie.... have you change the speed setting to max on SCAL? That helped mine. Its still slow for shadows but just a regular welded word it goes pretty quick.
Re: sloooooowwww
Posted: Sun Mar 23, 2008 1:52 am
by ailina
My regular words are fine, actually quite fast, but shadows are very slow. Doesn't really matter though, there is always something else to do while I'm waiting.
Re: sloooooowwww
Posted: Sun Mar 23, 2008 6:41 pm
by AnointedHands
edie wrote:I can't do a shadow yet because when I checked shadow it gave me an inkblot!!
edie
What do you mean by an inkblot?