Craft Edge

Just replaced my old Sizzix eclips 2 with a new Sizzix eclips 2. Plugged it in and it is cutting half an inch to the left of what my computer screen shows? I am using Sure cuts a lot. Any help fixing this would be greatly appreciated.

I'm not an eclips user but in general, when this happens with any cutter, it's based on what that cutter uses as a pointer for setting the origin. For example, if a cutter has a laser light, then that laser light is usually used to determine where the origin is set for a cut. If the cutter doesn't, then it's usually the location of the blade tip.