Craft Edge

Hi all,
I just received a new Create Machine and was going to begin using my wonderful SCAL on it, but..................................on the Craftedge site it says the firmware should be 1.51, I believe, but my machine has 1.52!!!!!!!!!!!!! I wrote to Todd to see if it was OK to cut, but he hasn't yet answered and I am dying to begin cutting but do not want to do anything Bad to my new machine. Anybody have any info on the 1.52 and if it is ok for SCAL?

Why don't you just try to cut something? You're not going to hurt anything. Either it'll cut or it won't and then you'll know.

Some of the expression machines are running version 1.016 but CraftEdge only shows 1.015 so I think there might have been a small update on the versions but Craftedge haven't updated documentation about it.
I would try cutting as suggested by Wreed - I think you will find it goes ok.

Raewyn