Page 1 of 1
Installing USB for SCAL4 with the Silver Bullet
Posted: Wed Jun 29, 2016 11:43 am
by IndelibleImpressions
I am unable to install the usb driver when setting up my Silver Bullet. I have downloaded the software. There is no option to choose any device, other than "GCC" - can someone please provide assistance?
Re: Installing USB for SCAL4 with the Silver Bullet
Posted: Wed Jun 29, 2016 3:54 pm
by papasue
You should contact support at craftedge directly. There is a form on the craftedge.com site.
Hope you get it figured out
Re: Installing USB for SCAL4 with the Silver Bullet
Posted: Fri Jul 01, 2016 8:15 am
by IndelibleImpressions
thanks - will do that!